Volumetric Concrete Mixed Fresh at Your Site
A mobile batching plant on a lorry chassis: materials travel dry and separate, and the concrete is produced as it is poured, so the quantity is settled on site.
- Licensed local partners across England, Scotland and Wales
- Waste paperwork provided with every job
- Free, no-obligation quotes
Trench footings rarely match the drawing. The digger finds soft ground, the inspector asks for another spit to be taken out, and the neat calculation made in the office is suddenly short. Volumetric concrete exists for exactly that situation. The lorry arrives carrying cement, sand, stone and water in separate bins and tanks, and a calibrated metering system feeds them into a mixing auger only when the operator starts the pour.
Nothing is mixed until it is needed, so the concrete is fresh at the point of discharge however far the vehicle has travelled, and production stops when the formwork is full. We arrange volumetric mixers through local operators in England, Scotland and Wales, subject to one covering your postcode. If your pour is large, continuous and tightly specified, look at ready-mix concrete as well; the concrete delivery page compares the two.
Volumetric Concrete services
How a volumetric mixer works
Think of it as a small batching plant that drives to the job. Aggregates sit in open bins, cement in a sealed hopper and water in a tank. Conveyors and valves, set by the operator for the chosen mix, deliver each material at a controlled rate into an inclined auger where they are blended in the last few moments before the concrete leaves the chute. A meter on the vehicle records the volume produced. The operator can pause between barrow loads, move to another part of the site and start again, which a drum mixer with a single batched load cannot do in the same way.
Where on-site mixing earns its place
The method is at its most useful when something about the job is unknown or varied. Typical examples are trench-fill foundations for extensions, pad bases for sheds and plant, fence and gate post runs along a boundary, reinstatement of utility trenches, and floor screeds that follow a foundation pour on the same visit. Remote sites benefit as well, since there is no batched load ageing in a drum on a long journey. Because production is matched to the pour, there is normally little or no surplus concrete left to dispose of.
Limits to be aware of
On-site mixing is not the answer to everything. Some specifications require plant-batched concrete with full batch records, and some clients or engineers will only accept supply from a plant with third-party quality certification. Ask the question before ordering. Very large continuous pours may also need a production rate that one vehicle cannot sustain, in which case several mixers or ready-mix supply is planned instead. If the specification is strict, send it to us in full and we will check with the operator whether it can be met.
Access and placing
A volumetric lorry stays on site for the whole pour, so it needs somewhere firm and reasonably level to stand without blocking a road it has no permission to occupy. The chute reaches only a short distance from the rear of the vehicle. Beyond that, concrete is barrowed or pumped; many operators can attend with a line pump, or one can be booked through our concrete pump hire service. Space and ground requirements vary by vehicle and are confirmed with your quote.
Preparing for the visit
Finish the excavation and have it inspected where building control requires. Lay and compact any sub-base beforehand, using MOT Type 1 or crushed concrete as the design allows. Spoil from the dig is best removed by grab hire or in a conventional skip, because soil and clay are too heavy to fill a large container. Then request a quote with the postcode, the type of work, a rough quantity and your preferred day.
Ideal for
- Trench-fill footings
- Extension foundations
- Shed and plant bases
- Utility reinstatement
- Floor screeds
- Remote or rural sites
Volumetric Concrete – your questions answered
Can’t see your question? Call 0333 121 1056 or send us a message.
Do I only pay for the volumetric concrete I use?
Charging is generally based on the metered volume produced, which is the main attraction of the method. Operators may also apply a minimum charge or a charge for time on site, so check the terms set out in your quote before the pour.
Is concrete mixed on site as strong as plant-batched concrete?
A properly calibrated volumetric mixer produces concrete to a stated mix design, and many operators work to recognised standards for this type of plant. Whether it is acceptable for a particular structure is for your engineer or building control body to confirm.
Can a volumetric lorry produce two different mixes on one visit?
Usually, yes. The operator adjusts the settings between pours, so a foundation mix can be followed by a leaner blinding mix or a screed. Tell us in advance which mixes you want so the vehicle is loaded with suitable materials.
How much notice is needed to book a volumetric mixer?
It depends on how busy operators near you are, and on the season. Give as much notice as you can, and be flexible about the time of day if possible. We confirm the slot when you book rather than promising one in advance.
Often booked with Volumetric Concrete
Need more than one service for the same project? Add them to one enquiry and we’ll coordinate them together.
Get a Quick Quote
Tell us the site postcode, the waste, the container size if you know it, and when you need it. Mention exchanges, other sites or specialist waste and we will include them. Photos of the waste and the access help.
ROROSkipHire.com is operated by Waste Cloud Ltd. Services are coordinated centrally and carried out by licensed local waste management and haulage partners across England, Scotland and Wales.